How to clean golf clubs properly

Clean golf clubs with warm water, a little dish soap, a soft brush, and a towel. Scrub the grooves, wipe the faces and soles, wash the grips with soap and water, dry everything fully, and store the clubs dry with headcovers on woods. Clean grooves after every round and do a deeper clean every few weeks during the season.

Golfer in action on a scenic golf course
Photo: Pexels

What you need before you start

Gather a bucket or sink of warm water, a small amount of dish soap, an old toothbrush or a soft nylon brush, a towel, and a dry cloth. Avoid wire brushes on most clubs, since they can scratch faces and damage finishes over time. A plastic tee or a wooden tee is useful for clearing packed dirt from grooves without gouging the metal. Keep a separate dry towel for grips, because grips need a different routine from metal heads.

Set up near a sink or outside where water can drain safely. Lay the clubs on a towel so they do not bang against each other while you work. Work through the set in order, from wedges to irons to woods, so you do not skip a club. This order also helps you spot worn grips, loose ferrules, or damaged faces before your next round.

How to clean iron and wedge grooves

Dip only the head of an iron or wedge in warm soapy water for a few minutes to loosen dirt. Scrub across the grooves with a soft brush, then use a tee to clear any dirt that is still packed in a groove. Rinse the head with clean water and dry it with a towel right away, paying attention to the hosel and the back of the head. Clean grooves matter most on wedges, because spin and control around the green depend on a clean face, and a wedge selection choice only helps if the grooves are kept clean.

Do this groove check as a drill after every round. Pick up each wedge, run a tee along three grooves, and look for dirt, sand, or grass left behind. If you find packed dirt, scrub that club again before it goes back in the bag. Repeat the check for your short irons as well, since those clubs are used for approach shots where spin and distance control matter most.

How to clean woods and hybrids without damage

Wipe wood and hybrid heads with a damp cloth and a little soapy water, rather than soaking the whole head. Soaking can let water into the hosel area and around adjustable parts, which is best avoided. Use a soft brush only on the face if dirt is stuck there, and use light pressure so you do not scratch the finish. Dry the head fully with a soft towel, then put the headcover back on before the club goes in the bag.

Check the sole and the face for scuffs while you clean, and note any cracks or loose parts for a shop to inspect. Do not use abrasive pads, harsh solvents, or a pressure washer on any clubhead. If a wood has an adjustable hosel, keep water away from the adjustment area and wipe it dry if it gets damp during play in rain.

How to clean grips so they stay tacky

Wash grips with warm water and a little dish soap, using your hand or a soft cloth to work the soap over the full grip. Rinse well, then towel dry and let the grips air dry before you put the clubs away. This routine removes sweat, sunscreen, and dirt that make grips feel slick. A clean grip lets you hold the club with lighter pressure, which helps your swing basics stay relaxed through the shot.

Use a grip check drill once a month. Hold each club as if you are about to swing, then relax your hands slightly and see if the club feels secure. If a grip still feels slick after washing, or if it is shiny, cracked, or hard, it is time to have it replaced. Do not use grip tape or extra layers as a fix for a worn grip, since that changes the grip size and can change how the club feels.

How to clean shafts and ferrules

Wipe steel and graphite shafts with a damp cloth, then dry them right away. For graphite shafts, use only a soft cloth and avoid abrasive pads, since scratches can weaken the surface over time. Wipe the ferrule, which is the small collar where the shaft meets the head, and check that it is not cracked or sliding down the shaft. If a ferrule is loose or a shaft shows a dent or crack, take the club to a repair shop before you play with it again.

Run a shaft wipe drill at the same time as your grip check. Wipe each shaft from grip to head, feel for nicks or rough spots, and look at the ferrule on every club. This takes only a minute per club, and it helps you catch damage early. Keep shafts dry in storage, and do not leave clubs in a hot car boot or a damp garage for long periods.

How to dry and store clubs after cleaning

Dry every club fully before it goes back in the bag. Water left on heads, in grooves, or around ferrules can lead to rust on steel parts and a musty smell in the bag. Use a dry towel for heads and grips, then leave the clubs out for a short time to air dry if they are still damp. Put headcovers on woods and hybrids, and keep clubs upright so heads do not bang together.

Store clubs in a cool, dry place, out of direct sun and away from damp floors. If you play in rain, towel dry the clubs as soon as you finish, and leave the bag open for a while so it can air out. A clean, dry bag also makes your next round easier, because you can find the right club fast and you start with grips that feel secure.

How often to clean clubs during the season

Clean grooves and wipe faces after every round, even if the round was short. This is the single habit that keeps spin and distance control consistent, and it takes only a few minutes with a towel and a brush kept in your bag. Wash grips every few rounds, or more often in hot and humid weather when sweat builds up fast. A full clean of heads, grips, and shafts every two to four weeks is enough for most golfers during the season.

Build cleaning into your practice plan so it does not get forgotten. For example, clean the clubs on the same day you do a short practice session, and check grips on the first practice day of each month. If you play on sandy or muddy courses, clean more often, since sand and mud pack into grooves faster. At the end of the season, do a full clean before storage so the clubs are ready for the first round next year.

Mistakes that shorten club life

The most common mistake is using harsh chemicals, abrasive pads, or a wire brush on faces and shafts. These can scratch finishes, dull grooves, and damage graphite. Another mistake is soaking clubs for a long time, especially woods, since water can work into areas that are hard to dry. A third mistake is putting wet clubs straight into a closed bag and leaving them there, which invites rust and grip damage.

Avoid drying clubs with high heat, and do not use a dishwasher or a pressure washer. If you are unsure about a finish, a coating, or an adjustable part, use only a damp cloth and a soft brush, and ask a shop for advice. When you choose new clubs, a guide on how to choose golf irons can help you match the set to your game, and clean clubs will help that set last longer.

Check your swing with clean clubs

After your clubs are clean, film a swing with FormCaddie to check your contact and checkpoints with clean grooves.

Download FormCaddie free

More guides