How to fix a pull: the ball that starts left and stays left

A pull is caused by a clubface that is square to an out to in swing path, so the ball starts left of target and flies straight. Fix it by checking your alignment first, since many pulls are aimed left, then squaring your shoulders and feet to the target line and letting the club travel down the line through impact. If the ball starts left and curves further left, that is a pull hook, not a pull, and if it starts left and curves right, that is a pull slice, and both need a different fix.

Golfer starting the downswing
Photo: Pexels

What a pull actually is

A true pull starts to the left of your target line and flies straight, finishing left of where it started by roughly the same amount. A pull hook starts left and curves further left. A pull slice starts left and curves back toward the target, which many golfers happily live with. Learn which one you hit before you change anything, because the fix for a pull makes a pull hook worse if the face is the real problem. Read ball flight laws: what actually controls direction and curve if the start direction and the curve still feel like one mystery. They are two separate problems with two separate fixes.

The two ingredients: face and path

Every pull needs a path that travels out to in, from outside the target line to inside it through impact, and a clubface that is square to that path. Where the ball starts tells you the path, how it curves tells you the face relative to that path. If the ball starts left and flies straight, your face is square to an outside path. If it starts left and curves left, your face is closed to that path as well. The first is a pull. The second is a pull hook. Same start, different surgery.

Check one: your alignment

Many pulls are not swing faults at all. They are alignment faults. Golfers who pull the ball often set up with their feet, hips and shoulders all pointing left of the target, usually because they are trying to guard against a slice and overcorrect. Stand behind the ball, pick a spot a foot in front of it on your target line, and set up to that spot, not to the distant target. Then lay a club across your toes and step back to check it. If the club points left of target, you have found your pull. See how to aim in golf: alignment that actually works for the full routine.

Check two: your shoulders

Your feet can point at the target while your shoulders point left, and the ball will follow the shoulders. This is the most common hidden cause of a pull. At address, your shoulders should run parallel to your target line, the same as your feet. A useful check is to hold a club across your chest at address and look at where it points. If it points left, square it up and hit ten balls before judging anything. Do not let your eyes drift to the target while you set up, because your shoulders will follow your eyes.

Check three: ball position

A ball played too far forward in the stance meets a clubface that has already closed by the time it arrives, so the face points left at impact and the ball pulls left. Move it one ball back and hit ten shots before judging anything. The correct position moves with the club: short irons sit near the middle of the stance, long irons sit a ball or two forward of that, and the driver sits off the inside of the lead heel. See ball position in the golf swing: the full guide for where each club should sit.

Check four: a path that is too far outside

An over the top downswing starts with the arms and shoulders instead of the lower body, and the club arrives at impact travelling out to in, across the target line. The tell is a divot pointing left of target on a ball that flew straight. Film down the line and watch the first move down from the top. The club should drop inside, behind you, not throw itself out toward the ball. If it comes over the top, see over the top: what causes it and how to fix it. Straightening the start of the downswing fixes the end more often than people expect.

Check five: a grip that is too strong

A grip that is too strong, with both hands rotated too far to the right at address, arrives at impact with the face already closed to the target, and the ball pulls left. Look down at address. You should see about two knuckles on your left hand and the V of each hand pointing roughly at your right shoulder. If you see three knuckles or four, or the Vs point well past your right shoulder, your grip is strong enough to pull it. Weaken it to neutral and give it two weeks. See the golf grip: neutral, strong and weak explained for the full check.

Check six: a body that stalls through impact

Sometimes the path is fine and the face is the problem in a different way. If your body stops turning through impact, your hands take over and flip the face closed, and the ball goes left. The tell is a finish where your chest still faces the ball instead of the target, or a swing that feels all arms after impact. Keep turning your chest toward the target through the ball and let the arms follow the body, not lead it. If your hips slide toward the ball instead of turning, see early extension: why your hips move toward the ball, because a stalled body and a sliding body often travel together.

The alignment stick drill that fixes most pulls

Lay one alignment stick on the ground on your target line, just outside the ball, and a second stick parallel to it at your feet, also on the target line. The two sticks make your setup honest in a way feel cannot. Hit twenty balls with the sticks down, checking your feet and shoulders against them before every shot. Most golfers find they were aiming ten to twenty yards left without knowing it. Keep the sticks in your warmup for a month. Alignment drifts back the moment you stop checking it.

The gate drill for start direction

Place two alignment sticks or headcovers on the ground forming a gate about two clubheads wide, a few feet in front of the ball, on your target line. The goal is to start the ball through the gate. This separates path from face in a way feel cannot: if the ball starts through the gate and stays straight, your path is fine and your alignment was the problem. If you cannot start it through the gate at all, work on path first. Keep the gate drill in your warmup for a month. It is the fastest feedback loop in golf.

The slow motion check

Hit ten balls at half speed with a mid iron, focusing only on where the club travels through impact. At half speed you can feel whether the club is travelling down the target line or swinging across it from outside to inside. Speed hides path problems because fast hands square anything and fast bodies cover a multitude of sins. If the pull disappears at half speed and returns at full speed, the fault is timing and tempo, not setup. Build the correct path slowly, then add speed in small steps. See golf swing tempo: the 3-to-1 ratio explained if the rush from the top is the part you cannot slow down.

When it is a pull hook instead

If your ball starts left and curves further left, you have a pull hook, and alignment alone will not fix it. The face is closed to the path as well as to the target, so you need the face fix too. Work on the grip check above first, then on letting the body rotation square the face through impact instead of flipping it closed with the hands. See how to fix a hook: causes, checks and drills for the full face work. Do not confuse the two misses: a pull is a straight ball going the wrong way, a pull hook is a curving ball going further wrong.

What your divots say about it

Divots diagnose pulls better than ball flight does. A true pull leaves a divot pointing left of target. A straight divot with a ball that went left points at alignment, not path, because the club travelled down the line and the line itself was wrong. No divot, or a thin strike with no turf taken, points at a ball position or timing problem rather than a path problem. Take foot spray or face tape for ten balls and note strike location alongside divot direction. The combination tells you whether to work on alignment, path, or hands. See what your divots tell you about your swing for the full read.

When it is the equipment

Occasionally the pull is not you. An iron with a lie angle that is too upright for your swing arrives toe up, and the face points left at impact on an otherwise good swing. If your alignment is square, your path is reasonable, and the ball still starts left on solid contact, get your lie angles checked. See is club fitting worth it for a mid handicapper. Equipment is the last suspect, not the first, but it is a real one.

Find the cause first

Film your swing and see whether it is the alignment, the path or the face.

Download FormCaddie free

More guides